Steel Wheel Spacer of the Last project
This project is for the wheel spacer of aluminium material.
We have already manufactured the steel wheel spacer for our clients for the last project.
This is the link:
Aluminum Wheel Spacer of This Project
Material
Aluminum, alu. 6061-T6
Specification
6x130PCD with CB75
Do you know what’s PCD?
PCD means Pitch Circle Diameter
PCD is usually measured in millimeters and increases with the number of screw holes. In addition to the hole pitch, you should also pay attention to the value of the “center hole”, which is the diameter of the center hole of the wheel hub (unit: mm), which determines whether the wheel hub can be installed in. If the center hole of the wheel hub is too small, the bearing shaft head will not be inserted. , so the center hole of the modified wheel hub must be larger than or equal to the original center hole.Also, do you know what’s is CB for the wheel spacer?
Center Bore (CB for short) is used to ensure that the wheel hub can be installed on the axle. Taking CB73.1 as an example, it means that the diameter of the center hole of the wheel hub is 73.1 mm. If the center hole is smaller than the diameter of the axle, the wheel hub cannot be installed on the car. If the center hole is larger than the diameter of the axle, it can be solved by matching the axle collar.
Height of the Wheel Spacer
This time, the client ordered both the heights 35mm and 40mm of the bulged part for the samples four sets each.
35mm
40mm
Bolt Installed
We equipped six sets of studs and nuts per one wheel Spacer as above pictures.
Packing
We packed each wheel spacer in one box, and four boxes into one carton. Outside we will use a strap to fasten it.
Express
For the small packages of samples, we always choose our economic express to deliver them directly to clients’ doors, like FedEx or special express airlines etc. We have a special discount from them.